Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
53
EtherNet/IP is enabled or disabled after the next restart.
You can display the current EtherNet/IP configuration with the show ethernetip command.
With this command, you change to the Interface Configuration mode.
There you can edit the settings for one interface. You select the interface with the
parameters of this command. If you specify a logical interface that does not exist, it will be
created. The name of the selected interface is displayed in the command prompt.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
interface{vlan<vlan-id(1-4094)>
<interface-type><interface-id>}
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
To Next Page
Loading...
Need help?
General
