Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
419
vap security cipher (access point)
Description
With this command, you configure the encryption method for the WPA authentication.
Note
This command is available only in access point mode.
Note
iPCF or iPCF-MC mode enabled
If you want encryption w
ith AES in iPCF or iPCF-MC mode, only keys with a 128 bit key
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Call up the command with the following parameters:
vap security cipher { auto | aes | tkip }
The parameters have the following meaning:
TKIP or AES is used depending on the capability of the other station.
AES (Advanced Encryption Standard): Strong symmetrical block encryption
method based on the Rijndael algorithm that further improves the functions of
TKIP (Temporal Key Integrity Protocol): A symmetrical encryption method with
the RC4 algorithm (Ron’s
Code 4). In contrast to the weak WEP encryption, TKIP uses changing keys
Note
The encryption methods "WEP" and "TKIP" are not available with the transmission standards
"802.11n" and "802.11n only".
The encryption method is configured.
You display the settings with the show wlan security <vapX 0/Y> command.
To Next Page
Loading...
Need help?
General
