Siemens SIMATIC NET Configuration Manual

Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
52 Configuration Manual, 10/2015, C79000-G8976-C351-05
The parameter has the following meaning:
Parameter
Description
Range of values / note
longitude
Input box for the longitude coordinate max. 32 characters
To use spaces in the entry, enter
the longitude coordinate in
quotes: coordinates longitude
"123 456"
Result
The longitude coordinate is created.
3.1.9.4
ethernetip
Description
With this command, you set whether EtherNet/IP will be enabled or disabled after the next
device restart.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ethernetip {off|on}
The parameters have the following meaning:
Parameter
Description
Range of values / note
off
EtherNet/IP will be disa-
bled after the next re-
start.
-
on
EtherNet/IP will be ena-
bled after the next re-
start.
• When EtherNet/IP is turned on, PNIO is turned off. The
switchover from EtherNet/IP and PNIO has no effect on
DCP.
• If a PROFINET connection is established; in other words
the PNIO AR status is "Online", you cannot enable
EtherNet/IP.

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols