Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
320 Configuration Manual, 10/2015, C79000-G8976-C351-05
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-
and 6GK5761-1FC00-0AB0 (US version))
With this command you specify that this IPv4 address band will not be used.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call the command without parameter assignment:
no pool-enable
The setting is disabled.
You display the setting with the show ip dhcp-server pools command.
You enable the setting with the
pool-enable command.
To Next Page
Loading...
