Layer 3 functions
9.1 NAT
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
379
Note
This command is only available in the client mode.
With this command, you configure the time period for the TCP / UDP connection. If no data
exchange takes place, the TCP / UDP connection is deleted from the translation table when
this time has elapsed.
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Call up the command with the following parameters:
nat {tcp|udp} timeout <seconds>
The parameters have the following meaning:
Period of time in seconds
The period of time is configured.
You show the NAT configuration and the translation list with the show nat command.
You delete the period of time with the
no nat timeout command.
show nat (Client) (Page 371)
To Next Page
Loading...
Need help?
General
