Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
231
You are in the interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
no switchport access vlan
The setting is reset to the default value.
You configure the setting with the switchport access vlan command.
You can display the status of this function and other information with the
show vlan port
config
command.
switchport ingress-filter
Description
With incoming packets, the ingress filter checks whether the port on which the packet was
received belongs to the sending VLAN. If this is not the case, the packet is not processed.
With this command, you enable the ingress filter.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
switchport ingress-filter
The ingress filter is activated.
You disable the filter with the no switchport ingress-filter command.
You can display the status of the ingress filter and other settings with the
show vlan port
config
command.
To Next Page
Loading...
Need help?
General
