Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
348 Configuration Manual, 10/2015, C79000-G8976-C351-05
snmp v1-v2 readonly
Description
With this command, you block write access for SNMPv1 and SNMPv2 PDUs.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
snmp v1-v2 readonly
Write access for SNMPv1 and SNMPv2 PDUs is blocked.
You release write access for SNMPv1 and SNMPv2 PDUs with the no snmp v1-v2 readonly
command.
no snmp v1-v2 readonly
Description
With this command, you enable write access for SNMPv1 and SNMPv2 PDUs.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no snmp v1-v2 readonly
To Next Page
Loading...
Need help?
General
