Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
319
mand is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-
and 6GK5761-1FC00-0AB0 (US version))
With this command you specify that this IPv4 address band will be used.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call the command without parameter assignment:
pool-enable
The setting is enabled.
Note
If the IPv4 address band is enabled, DHCP options (option ...) and static assignments (static
leases) can no loner be edited.
You display the setting with the show ip dhcp-server pools command.
You disable the setting with the
no pool-enable command.
To Next Page
Loading...
Need help?
General
