Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
393
wlan security ap-radius-authenticator address
Description
With this command, you configure the IP address of the RADIUS server.
Note
This command is available only in access point mode.
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Call up the command with the following parameters:
wlan security ap-radius-authenticator address <index (1-2)> {ipv4 <ucast_addr> |
fqdn-name <FQDN>}
The parameters have the following meaning:
Index of the RADIUS server
Keyword for an IPv4 address
Enter a valid IPv4 address.
Keyword for a domain name
Domain name (Fully Qualified Domain Name)
Maximum of 100 characters
The RADIUS server is enabled.
You display the setting with the show wlan security ap-radius-authenticator command.
show wlan security ap-radius-authenticator (Access Point) (Page 389)
To Next Page
Loading...
Need help?
General
