Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
63
The parameters have the following meaning:
the sending of LLDP packets is enabled
the receipt of LLDP packets is enabled
At system start or when using the restart command with the option memoryor factory, the
following defaults apply:
● Sending and receipt of LLDP packets are enabled.
Note
Enabling both options
When you call this command, you can only select one option.
If you want to enable both options, call up the command again.
The setting is configured.
You disable the sending or receipt of LLDP packets with the no lldp command.
You display the status of LLDP with the
show lldp status command.
With this command, you disable the sending and receipt of LLDP packets on the interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
no lldp{transmit|receive}
To Next Page
Loading...
Need help?
General
