Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
279
You are in the MSTP Configuration mode.
The command prompt is as follows:
cli(config-mst)#
Call the command without parameters:
no name
The name is reset to the default value.
You configure the name of the MST region with the name command.
You display this setting and other information with the
show spanning tree mst
configuration
command.
With this command, you assign a revision number to the MST region.
You are in the MSTP Configuration mode.
The command prompt is as follows:
cli(config-mst)#
Call up the command with the following parameters:
revision <revision-no(0-65535)>
The parameters have the following meaning:
Value of the revision number 0 ... 65535
To Next Page
Loading...
Need help?
General
