Siemens SIMATIC NET Configuration Manual

Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
236 Configuration Manual, 10/2015, C79000-G8976-C351-05
6.2.4.1
name
Description
With this command, you assign a name to the VLAN.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
name <vlan-name>
The parameter has the following meaning:
Parameter
Description
Range of values / note
vlan-name
Name that will be assigned to the
VLAN
max. 32 characters
Result
The VLAN is assigned a name.
Further notes
You delete name assignment for a VLAN with the no name command.
6.2.4.2
no name
Description
With this command, you delete the name assignment for a VLAN.
Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols