Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
57
The parameters have the following meaning:
PNIO is deactivated. If a PROFINET connection is established; in
other words the PNIO AR status is "Online",
PNIO is activated. When PNIO is turned on, EtherNet/IP is
turned off. The switchover from PNIO and
EtherNet/IP has no effect on DCP.
PNIO is enabled or disabled after the next restart.
You display the current PNIO configuration with the show pnio command.
system contact
Description
With this command, you enter contact information for the system.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
system contact <string>
The parameter has the following meaning:
Input box for contact information
The contact information is created in the system.
To Next Page
Loading...
Need help?
General
