Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
229
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
switchport acceptable-frame-type
Description
With this command, you configure which types of frames the interface accepts.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged}
The parameters have the following meaning:
All frames (with and without VLAN variables) are accepted
Only frames with VLAN variables are accepted
At system start or when using the restart command with the option memoryor factory, the
following defaults apply:
● The function is configured for
all.
The setting is enabled.
You can display the status of this function and other information with the show vlan port
config
command.
To Next Page
Loading...
Need help?
General
