Diagnostics
11.1 Diagnostics
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
444 Configuration Manual, 10/2015, C79000-G8976-C351-05
no client config
Description
With this command, you disable one of the clients that processes or forwards the messages
of the device.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
no client config {syslog|trap|email|all}
The parameters have the following meaning:
Disables the client that sends the messages to the Syslog server
Disables the client that sends the SNMP traps
Disables the client that sends the e-mails
Disables all clients at once
The client selected for the transfer is disabled.
You display the status of the events and the clients with the show events config command.
You enable the function with the
client config command.
To Next Page
Loading...
Need help?
General
