Siemens SIMATIC NET

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
172 Configuration Manual, 10/2015, C79000-G8976-C351-05
6.1.5.19
wlan background scan interval (client)
Description
With this command, you specify the Interval at which the client scans for further access
points.
Note
This command is only available
in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan background scan interval <ms(300-60000)>
The parameter has the following meaning:
Parameters
Description
Range of values / note
ms
Time in milliseconds (ms) 300 ... 60 000
Default: 5000
Result
The interval is specified.
Further notes
You show the set interval with the show wlan client <wlan 0/X> command.