Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
135
show wlan advanced-11n
Description
The command shows the 802.11n configuration.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show wlan advanced-11n <wlan 0/X>
The parameter has the following meaning:
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The following 802.11n configuration is displayed:
● A-MPDU
● A-MPDU limit [frames]
● A-MPDU limit [bytes]
● Guard Interval (only with access points)
show wlan available-ap-list (client)
Description
This command shows the access points to which the client device can establish a wireless
link or with which the client device is connected.
Note
This command is only available in the client mode.
To Next Page
Loading...
