Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
45
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If no parameters are specified, the counters for all interfaces are reset.
The counters of the interface are reset.
You can display the statistical information of the interfaces with the show interfaces -
counters
command.
configure terminal
Description
With this command, you change to the Global configuration mode.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call the command without parameters:
configure terminal
You are now in the Global configuration mode.
The command prompt is as follows:
cli(config)#
You exit the Global configuration mode with the end command.
To Next Page
Loading...
Need help?
General
