Diagnostics
11.1 Diagnostics
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
441
Call up the command with the following parameter:
fault report ack <fault-state-id>
The parameter has the following meaning:
ID of the mes-
sage
Enter the ID of the message for the "Cold/Warm Start"
event.
To obtain the ID, use the "show events faults status"
The message is acknowledged.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you change to the EVENTS configuration mode.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
events
To Next Page
Loading...
Need help?
General
