Diagnostics
11.2 Syslog client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
454 Configuration Manual, 10/2015, C79000-G8976-C351-05
Commands in the Events configuration mode
This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
events command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you configure the Syslog server address.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli (config-events) #
Call up the command with the following parameters:
syslogserver {ipv4 <ucast_addr> | fqdn
-name <FQDN>} [<port(1
-65535)>] The parameters have the following meaning:
Keyword for an IP address
Syslog server IPv4 Address
Enter a valid IPv4 address.
Keyword for a domain name
Domain name (Fully Qualified Domain
Maximum of 100 characters
Serverport 1 .. 65535
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameters from the parameter list, the default value is used.
The settings for the Syslog server are configured.
To Next Page
Loading...
Need help?
General
