Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
389
Call up the command with the following parameters:
show wlan security <wlan 0/X | vapX 0/Y> [context <Id (1-8)>]
The parameters have the following meaning:
WLAN interface
Only available in client mode
Enter a valid interface.
VAP interface
Only available in Access Point mode
Enter a valid interface.
Keyword for a security context
Enter a valid security context ID. Available only in client mode
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The settings are displayed.
show wlan security ap-radius-authenticator (Access Point)
Description
This command shows the settings of the RADIUS server.
Note
This command is available only in access point mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameter assignment:
show wlan security ap-radius-authenticator
To Next Page
Loading...
Need help?
General
