Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
274 Configuration Manual, 10/2015, C79000-G8976-C351-05
You configure the setting with the spanning-tree mst command (properties).
You display these settings and other information with the commands that start with
show
spanning tree ...
.
spanning-tree mst hello-time
Description
With this command, you configure the Hello time after which the bridge sends its
configuration frames (BPDUs).
A change to this value applies to all MST instances active on this interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
spanning-tree mst hello-time <seconds(1-2)>
The parameter has the following meaning:
Time after which the bridge sends its
configuration frames (BPDUs)
1 ... 2
The setting for the hello time is configured.
You can reset the setting for the hello time to the default with the no spanning-tree mst
hello-time
command.
You display this setting and other information with the commands that start with
show
spanning tree ...
.
To Next Page
Loading...
Need help?
General
