Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
289
With this command, you configure a static entry in the IP routing table.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
ip route <gateway>
The parameter has the following meaning:
Specifies the IP address of the gateway
The entry is configured.
You delete an entry from the IP routing table with the no ip route command.
You display the IP routing table with the
show ip route command.
With this command, you delete a static entry from the IP routing table.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General
