Network protocols
7.6 HTTP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
359
With this command, you reset the SMTP port to the default.
The default value is 25.
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Call the command without parameters:
no smtp-port
The SMTP port is reset to the default value.
You configure the setting with the smtp-port command.
You display the setting with the
show smtp-port command.
This section describes commands of the Hypertext Transfer Protocol (HTTP).
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
do show cli-console-timeout
To Next Page
Loading...
Need help?
General
