Load control
8.1 Dynamic MAC aging
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
368 Configuration Manual, 10/2015, C79000-G8976-C351-05
Call the command without parameters:
show mac-address-table aging-time
The time is displayed.
show mac-address-table aging-status
Description
This command shows whether or not MAC aging is enabled.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show mac-address-table aging-status
The status of the MAC aging is displayed.
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
To Next Page
Loading...
