Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
61
Electrical interfaces can be operated in full duplex mode or half duplex mode. The options
here depend on the connected device.
Optical connections are always operated in full duplex mode since they have a fiber for each
transmission direction.
With this command, you configure the duplex mode of an interface. The same mode must be
set for connected interfaces.
● Autonegotiation is disabled.
● You are in the Interface configuration mode of an electrical interface.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
duplex {full|half}
The parameters have the following meaning:
The Interface will be operated in full
Default: full
The Interface will be operated in half
duplex mode
-
The duplex mode of the interface is configured.
You can reset the duplex mode of the Interface to the default value with the no duplex
command.
You disable autonegotiation with the
no negotiation command.
To Next Page
Loading...
Need help?
General
