Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
74 Configuration Manual, 10/2015, C79000-G8976-C351-05
Commands in the LOADSAVE configuration mode
This section describes commands that you can call up in the LOADSAVE configuration
mode.
In the Global Configuration mode, enter the
loadsave command to change to this mode.
You display the valid file types for the commands in the LOADSAVE Configuration mode
with the global command
show loadsave tftp.
● If you exit the LOADSAVE configuration mode with the
exitcommand, you return to the
Global Configuration mode.
● If you exit the LOADSAVE configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you call up the possible files or delete a specific file.
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Call up the command with the following parameters:
delete{showfiles|filetype<filetype>}
The parameters have the following meaning:
Shows the available files
Keyword for the file type to be deleted
The files are displayed or the file is deleted.
With the "show loadsave files" command, you can display the file types.
To Next Page
Loading...
Need help?
General
