Diagnostics
11.1 Diagnostics
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
449
With this command, you configure and enable the monitoring of the physical network
connections for cable breaks or for pulling of the connector.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Call up the command with the following parameters:
link {up|down}
The parameters have the following meaning:
Only the establishment of a connection is signaled
Only a break on a connection is signaled
The settings for monitoring the physical network connections have been configured.
You can display the current setting with the show events faults config command.
You disable the function with the
no link command.
With this command, you disable the monitoring of the physical network connections for cable
breaks or for pulling of the connector.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
To Next Page
Loading...
Need help?
General
