Siemens SIMATIC NET

SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
35
Configuration
3
The following is described in this section:
● System settings
● Saving and loading configurations and firmware
3.1
System
This section describes commands with which general system properties can be displayed
and configured.
3.1.1
The "show" commands
This section describes commands with which you display various settings.
With the command
do [command] you can execute the "show" commands in every
configuration mode.
To do this, you replace
[command] with the "show" command that you want to execute.
Example
do show cli-console-timeout
3.1.1.1
show cli-console-timeout
Description
This command shows the global configuration for the timeout of the CLI console.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show cli-console-timeout