Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
411
wlan security dot1x eap-authentication-type (client)
Description
With this command, you specify which RADIUS authentication methods the client offers to
the RADIUS server. With "
auto", the client offers a RADIUS server all supported methods.
Any other selection restricts the support by the client to this one method.
Note
This command is only available in the client mode.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Call up the command with the following parameters:
wlan security dot1x eap-authentication-type { show-types | <type> }
The parameters have the following meaning:
Lists the available authenti-
• auto
Client offers RADIUS server all methods
• eap-tls
Extensible Authentication Protocol - Transport
Layer Security: Uses certificates for authentica-
tion
•
eap-ttls
Extensible Authentication Protocol - Tunnel
Transport Layer Security: After setting up the
TLS tunnel, MS-CHAPv2 is used for internal au-
thentication.
•
peap
Protected Extensible Authentication Protocol: Al-
ternative draft protocol of IETF for EAP-TTLS
Value that contains the au-
thentication method
The authentication method is specified.
You display the settings with the show wlan security command.
To Next Page
Loading...
Need help?
General
