Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
138 Configuration Manual, 10/2015, C79000-G8976-C351-05
Call up the command with the following parameters:
show wlan client <wlan 0/X>
The parameter has the following meaning:
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
The following client settings are displayed:
● MAC Mode
● Manual MAC Address
● Any SSID
● Roaming Threshold
● Background scan mode
● Background Scan Interval
● Scan Channels
show wlan client-list (access point)
Description
This command shows a table with the clients logged on with the access point as well as
additional information, for example status, signal strength, MAC address.
Note
The command is available only in access point mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General
