System time
5.3 SNTP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
129
no sntp unicast-server
Description
With this command, you delete the attributes for an SNTP unicast server and reset the
address.
You are in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Call up the command with the following parameters:
no sntp unicast-server {ipv4 <ucast_addr> | fqdn-name <FQDN>}
The parameters have the following meaning:
Keyword for an IP address
Value for an IPv4 unicast address
Enter a valid IPv4 unicast address
Keyword for a domain name
Domain name (Fully Qualified Domain
Maximum of 100 characters
The SNTP unicast server is reset to the default value.
You configure the setting with the sntp unicast-server command.
You display this setting and other information with the
show sntp unicast–mode status
command.
sntp client addressing-mode
Description
With this command, you configure the addressing mode of the SNTP client as unicast or
broadcast.
To Next Page
Loading...
Need help?
General
