Siemens SIMATIC NET

Functions specific to SCALANCE
4.4 iPCF-MC
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
105
Syntax
Call the command without parameter assignment:
wlan ipcf-mc
Result
iPCF-MC is enabled.
Further notes
You disable iPCF-MC with the no wlan ipcf-mc command.
You display the setting with the
show wlan ipcf-mc command.
4.4.2.2
no wlan ipcf-mc
Note
The command is only available with the following device:
•
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
Description
With this command, you disable iPCF-MC on this SCALANCE W700 device.
Requirement
You are in the WLAN configuration mode.
The command prompt is as follows:
cli(config-wlan)#
Syntax
Call the command without parameter assignment:
no wlan ipcf-mc
Result
iPCF-MC is disabled.
Further notes
You enable iPCF-MC with the wlan ipcf-mc command.
You display the setting with the
show wlan ipcf-mc command.