Configuration
3.4 Configuration Save & Restore
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
86 Configuration Manual, 10/2015, C79000-G8976-C351-05
You disable the function with the no auto-save command.
You can display the status of this function and other information with the
show device
information
command.
With this command, you disable the auto save function.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no auto-save
The auto save function is disabled. The Trial mode is activated.
You enable the function with the auto-save command.
You can display the status of this function and other information with the
show device
information
command.
You save changes to the configuration in the Trial mode with the
write startupconfig
command.
To Next Page
Loading...
Need help?
General
