Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
233
Call up the command with the following parameters:
switchport priority default <0-7>
The parameter has the following meaning:
Value for the priority default 0 ... 7
The setting for the default priority of the interface is configured.
You reset the priority default to the original default with the no switchport priority default
command.
You display this setting and other information with the
show vlan port config command.
no switchport priority default
Description
With this command, you reset the priority default for the interface to the default value.
The default value is 0.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call the command without parameters:
no switchport priority default
The setting is reset to the default value.
You configure the priority default with the switchport priority default command.
You display this setting and other information with the
show vlan port config command.
To Next Page
Loading...
Need help?
General
