Siemens SIMATIC NET

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
163
The parameter has the following meaning:
Parameter
Description
Range of values / note
frames
Number of frames that are grouped to-
gether in one AMPDU data packet.
2...64
Default: 32
Result
The number of frames is specified.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
6.1.5.9
wlan amsdu
Description
With this command, you enable the sending of A-MSDU data packets. Several MSDUs with
the same destination address are bundled into an A-MSDU and are sent together. This
reduces the network load. The function is enabled as default.
Requirement
● The IEEE 802.11n transmission standard is enabled.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan amsdu
Result
The sending of A-MSDU data packets is enabled.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
You disable the function with the
no wlan amsdu command.