Description
2.6 General CLI commands
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
31
The command "?"
Description
With this command, you call up the command list.
Enter a question mark to obtain a list of all permitted commands in the current mode:
?
For this command, you do not need to press the enter key. The command executes
immediately after you type the character.
The mode-specific as well as the global commands are displayed.
Note
Incomplete command names
If you have specified an incomplete command when calling the
help function, a list of all
commands that start with the term you have entered is created.
Note
Output in pages
With long lists, the results are displayed as pages. If
-- more --
appears at the lower edge of
the display, you can move to the next page
with the spacebar. If the display is in pages, you
cannot page back. You exit the page display with the q
key.
Completion of command entries
Description
The command interpreter of the Command Line Interface supports you when you enter
commands.
As soon as the first characters of the command have been entered in the input line, the
system can complete the entry as long as the character string is unambiguous.
This can be repeated after entering further characters.
Enter the first characters of the command.
Press the tab key.
To Next Page
Loading...
Need help?
General
