Siemens SIMATIC NET - IECEx Explosion Protection Approvals

Configuration
3.4 Configuration Save & Restore
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
83
The parameters have the following meaning:
Parameter
Description
Range of values / note
syslog
Shows the configuration settings of the Syslog
function
-
dhcp
shows the configuration settings of the Dynamic
Host Configuration Protocol
-
qos
shows the configuration settings of QoS (Quali-
ty of Service)
-
stp
shows the configuration settings of the Span-
ning Tree Protocol
-
vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 ... 4094
interface
Shows that an interface description follows
-
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the interface
ssh
Shows the configuration settings of the Secure
Shell protocol
-
ssl
Shows the configuration settings of the Secure
Sockets Layer protocol
-
acl
Shows the configuration settings of the access
control list
-
ip
Shows the configuration settings of the Internet
Protocol
-
snmp
Shows the configuration settings of the Simple
Network Management Protocol
-
radius
Shows the configuration settings of the Remote
Authentication Dial-In User service
-
sntp
Shows the configuration settings of the Simple
Network Time Protocol
-
http
Shows the configuration settings of the Hyper-
text Transfer Protocol
-
locked-port
Shows the configuration settings of the locked
port function.
auto-logout
Shows the configuration settings of the auto
logout function
-
time
Shows the configuration settings of the system
time
-
ntp
Shows the configuration settings of the Network
Time Protocol
-
auto-save
Shows the configuration settings of the auto
save function
-
wlan
Shows the configuration settings of the WLAN
-
all
Shows all configuration settings
-
For information on identifiers of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 25)".