Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
272 Configuration Manual, 10/2015, C79000-G8976-C351-05
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
spanning-tree mst<instance-id(1-64)>
{cost(0-200000000)|port-priority (0-240)|disable}
The parameters have the following meaning:
Number of the addressed instance
Costs of the port for calculating the
lowest cost path.
0 ... 200000000
Default:
• 200000 for physical interfaces
• 199999 for port channels
Priority of the interface 0 ... 240 in steps of 16
disables the interface for multiple
spanning tree
-
Default:
The Multiple Spanning Tree func-
tion is enabled on the interface
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
The selected property is configured.
You can reset the setting to the default with the no spanning-tree mst (properties) command.
You display these settings and other information with the commands that start with
show
spanning tree ...
.
To Next Page
Loading...
Need help?
General
