Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
344 Configuration Manual, 10/2015, C79000-G8976-C351-05
Call up the command with the following parameters:
snmp targetaddr <TargetAddressName> param <ParamName>
{ipv4 <IPAddress> | fqdn-name <FQDN>}
[timeout <Seconds(1-1500)] [retries <RetryCount(1-3)]
[taglist <TagIdentifier | none>] [{volatile | nonvolatile}]
[port <integer (1-65535)>]
The parameters have the following meaning:
Name of the target address
Keyword for the parameter name -
Keyword for an IPv4 address -
Enter a valid IPv4 unicast address.
Keyword for a domain name
Domain name (Fully Qualified Do-
Maximum of 100 characters
Keyword for the time the SNMP
agent waits for a response before it
repeats the inform request message
-
Keyword for the maximum number of
attempts to obtain a response to an
-
Tag identifier that selects the desti-
Specify the tag identifier.
nonvolatile
Specifies whether the settings re-
main following a restart.
•
volatile:
The default settings are used af-
ter a restart.
•
nonvolatile:
The saved settings are used af-
ter a restart.
Keyword for the port number at
which the SNMP manager receives
traps and inform messages
-
Port number 1 ... 65535
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 25)".
If optional parameters are not specified when configuring, the default values apply.
The SNMP target address is configured.
To Next Page
Loading...
Need help?
General
