Security and authentication
10.3 Management Access Control List
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
432 Configuration Manual, 10/2015, C79000-G8976-C351-05
The parameters have the following meaning:
Specifies the network or the IP address
for which the IP manager is authorized
Enter a valid IP address or a
Subnet mask that restricts the authori-
zation
Enter a valid mask
Decimal representation of the mask as
0 ... 32
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
An authorized manager is deleted from the list.
You configure the interfaces and protocols via which an authorized manager is allowed to
access the device with the
authorized-manager ip-source command.
You show the information about the configuration of the authorized managers with the
show
authorized-manager
command.
To Next Page
Loading...
Need help?
General
