Siemens SIMATIC NET - Measuring and Interpreting Optical Receive Levels

Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
49
Syntax
Call up the command with the following parameters:
ping [ip]<destination-address>
[size<byte(0-2080)>]
[count<packet_count(1-10)>]
[timeout<seconds(1-100)>]
The parameters have the following meaning:
Parameter
Description
Range of values/note
ip
Uses an IP address
-
destination-
address
Address of the called node Enter a valid IP address or a valid
hostname.
size
Keyword for the size of the packets to be
transferred
-
byte
Keyword for the size of the packets in bytes
0 … 2080
count
Keyword for the number of packets to be
requested
-
packet_count
Number of packets
1 … 10
timeout
Response wait time
If this time expires, the request is reported
as "timed out".
-
seconds
Time to the timeout in seconds
1 … 100
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameters from the parameter list, the default values are used.
At system start or when using the
restart command with the option memoryor factory, the
following defaults apply:
Parameter
Default value
size
32
count
3
time-out
1
Result
The messages relating to the response of the called node are displayed.