EasyManuals Logo

ST STM32L0x3 User Manual

ST STM32L0x3
1043 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1034 background imageLoading...
Page #1034 background image
Revision history RM0367
1034/1043 RM0367 Rev 7
14-Nov-2016
5
(continued)
General-purpose timers (TIM2/3)
Replace TIM2_SMCR by TIMy_SMCR in Section : Using one timer to
start another timer and Section : Starting 2 timers synchronously in
response to an external trigger.
Updated PSC[15:0] bitfield definition in Section 21.4.11: TIMx
prescaler (TIMx_PSC).
Changed TIMx capture/compare register 1 (TIMx_CCR1), TIMx
capture/compare register 2 (TIMx_CCR2), TIMx capture/compare
register 3 (TIMx_CCR3) and TIMx capture/compare register 4
(TIMx_CCR4) registers to read-only when CCy channel is configured
as input.
Replace USB_OE by USB_NOE in TIM3 option register (TIM3_OR).
Lite timers (TIM21/22)
Updated PSC[15:0] bitfield definition in Section 22.4.10: TIM21/22
prescaler (TIMx_PSC).
Changed TIMx_ARR reset value to 0xFFFF FFFF in Section 22.4.11.
Changed TIM21/22 control register 1 (TIMx_CR1) and TIM21/22
control register 2 (TIMx_CR2) registers to read-only when CCy
channel is configured as input.
Basic timers (TIM6/7)
Updated PSC[15:0] bitfield definition in Section 23.4.7: TIM6/7
prescaler (TIMx_PSC).
Changed TIMx_ARR reset value to 0xFFFF FFFF in Section 23.4.8.
Real-time clock (RTC)
Replaced HSE/32 by HSE prescaled in Figure 202: RTC block
diagram.
Added Section 27.3: RTC implementation. Removed notes related to
RTC_TAMP3 availability depending on categories in RTC_ISR and
RTC_TAMPCR.
Updated Section 27.4.15: Calibration clock output.
Section 27.7.3: RTC control register (RTC_CR):
Added caution note at the end of the section.
Updated ADD1H and SUB1H descriptions
Updated caution note at the end of Section 27.7.16: RTC tamper
configuration register (RTC_TAMPCR).
Updated RTC backup registers (RTC_BKPxR) register description.
Inter-integrated circuit interface (I2C)
Updated Section 28.4.5: I2C initialization, Section 28.4.8: I2C slave
mode and Section 28.7.5: Timing register (I2C_TIMINGR).
Updated:
Note on Section 28.4.9: I2C master mode
Bit 13 on Section 28.7.2: Control register 2 (I2C_CR2)
Table 181. Document revision history (continued)
Date Revision Changes

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ST STM32L0x3 and is the answer not in the manual?

ST STM32L0x3 Specifications

General IconGeneral
BrandST
ModelSTM32L0x3
CategoryMicrocontrollers
LanguageEnglish

Related product manuals