ST STM32L0x3 User Manual

RM0367 Rev 7 221/1043
RM0367 Reset and clock control (RCC)
225
Bit 14 CSSLSED: CSS on LSE failure detection flag
This bit is set by hardware to indicate when a failure has been detected by the clock security
system on the external 32 kHz oscillator (LSE).
It is cleared by a power-on reset or by an RTC software reset (RTCRST bit).
0: No failure detected on LSE (32 kHz oscillator)
1: Failure detected on LSE (32 kHz oscillator)
Bit 13 CSSLSEON CSS on LSE enable bit
This bit is set by software to enable the Clock Security System on LSE (32 kHz oscillator).
CSSLSEON must be enabled after the LSE and LSI oscillators are enabled (LSEON and
LSION bits enabled) and ready (LSERDY and LSIRDY flags set by hardware), and after the
RTCSEL bit is selected.
Once enabled this bit cannot be disabled, except after an LSE failure detection (CSSLSED
=1). In that case the software MUST disable the CSSLSEON bit.
Reset by power on reset and RTC software reset (RTCRST bit).
0: CSS on LSE (32 kHz oscillator) OFF
1: CSS on LSE (32 kHz oscillator) ON
Bits 12-11
LSEDRV; LSE oscillator Driving capability bits
These bits are set by software to select the driving capability of the LSE oscillator.
They are cleared by a power-on reset or an RTC reset. Once “00” has been written, the
content of LSEDRV cannot be changed by software.
00: Lowest drive
01: Medium low drive
10: Medium high drive
11: Highest drive
Bit 10 LSEBYP: External low-speed oscillator bypass bit
This bit is set and cleared by software to bypass oscillator in debug mode. This bit can be
written only when the LSE oscillator is disabled.
It is reset by setting the RTCRST bit or by a POR.
0: LSE oscillator not bypassed
1: LSE oscillator bypassed
Bit 9 LSERDY: External low-speed oscillator ready bit
This bit is set and cleared by hardware to indicate when the LSE oscillator is stable. After the
LSEON bit is cleared, LSERDY goes low after 6 LSE oscillator clock cycles.
It is reset by setting the RTCRST bit or by a POR.
0: External 32 kHz oscillator not ready
1: External 32 kHz oscillator ready
Bit 8 LSEON: External low-speed oscillator enable bit
This bit is set and cleared by software.
It is reset by setting the RTCRST bit or by a POR.
0: LSE oscillator OFF
1:LSE oscillator ON

ST STM32L0x3 Specifications

General

Brand	ST
Model	STM32L0x3
Category	Microcontrollers
Language	English