R&S ZNB Series - CALCulate:FMODel... (other)

Command reference
R&S
®
ZNB/ZNBT
921User Manual 1173.9163.02 ─ 62
Manual operation: See "Apply" on page 634
CALCulate:FMODel:SFD:TOTaldiffcfg <SFDPortConfig>
Tells the SFD tool about the port ordering of the test fixture.
Parameters:
<SFDPortConfig> ODD | NON
ODD: odd ports are on the left and even ports are on the right
NON: ports 1 to N are on the left and ports N+1 to 2·N are on
the right
Manual operation: See "Total Port Ordering" on page 639
CALCulate:FMODel... (other)
CALCulate:FMODel:DIRectory........................................................................................ 921
CALCulate:FMODel:DIRectory:DEFault............................................................................921
CALCulate:FMODel:DIRectory:DEFault:CLEar..................................................................921
CALCulate:FMODel:REName..........................................................................................922
CALCulate:FMODel:DIRectory <String>
Defines the common working directory of the ISD, SFD and EZD fixture modeling tools.
Parameters:
<String> Directory path, either absolute or relative to the current directory
(MMEMory:CDIRectory).
Manual operation: See "Output Settings" on page 628
CALCulate:FMODel:DIRectory:DEFault
Resets the common working directory of the ISD, SFD, and EZD tool to its default
C:\Users\Public\Documents\Rohde-Schwarz\Vna\Embedding.
Suffix:
<Ph_pt>
.
This suffix is ignored.
Usage: Event
Manual operation: See "Output Settings" on page 628
CALCulate:FMODel:DIRectory:DEFault:CLEar
Deletes all files in the common default working directory of the of the ISD, SFD, and
EZD tool (C:\Users\Public\Documents\Rohde-Schwarz\Vna\Embedding).
Usage:
Event
Manual operation: See "Output Settings" on page 628
SCPI command reference