R&S ZNB Series User Manual

GUI reference
R&S
®
ZNB/ZNBT
763User Manual 1173.9163.02 ─ 62
Remote command:
SYSTem:AGC:GLOBal:METHod
Recovery tab
Provides a single function "Boot into Recovery Screen" that allows you reboot the
instrument and launch the "R&S Recovery Environment". From there you can restore
the original system image (including operating system and firmware).
See Chapter 12.2, "System recovery", on page 1538.
HUMS tab
The "HUMS" tab allows you to enable and configure R&S HUMS (see Chapter 4.7.12,
"Health and usage monitoring service (HUMS)", on page 253). It is only available if
software option R&S ZNB/ZNBT-K980 is installed.
Setup softtool

R&S ZNB Series Specifications

General

Brand	R&S
Model	ZNB Series
Category	Measuring Instruments
Language	English