R&S ZNB Series User Manual

GUI reference
R&S
®
ZNB/ZNBT
764User Manual 1173.9163.02 ─ 62
Common controls
State (Device Utilization)/Status
Enables/disables the HUMS service.
The "Status" LED indicates the current state of the HUMS service:
●
grey: inactive
●
green: up and runnning
If HUMS has been used before, turning on restores the previous protocol settings.
Remote command:
DIAGnostic:HUMS:STATe
REST ← State (Device Utilization)/Status
Enables/disables the REST interface to the HUMS service.
Remote command:
SYSTem:COMMunicate:REST:ENABle
SNMP ← State (Device Utilization)/Status
Enables/disables the SNMP interface to the HUMS service and allwos you to select the
supported SNMP protocol versions.
Depending on the enabled versions, different parts of the Protocol subtab are enabled.
Note: If you activate v2c, version v1 is also active.
Remote command:
SYSTem:COMMunicate:SNMP:VERSion
Delete HUMS History
Allows you to delete the previousy collected health and monitoring information from the
instrument.
Remote command:
DIAGnostic:HUMS:DELete:ALL
Export HUMS History
Allows you to export the previousy collected health and monitoring information to a zip-
ped JSON file.
Remote command:
DIAGnostic:HUMS:DELete:ALL
Protocol subtab
Gives access to SNMP configuration options for protocol version 2c and 3.
SNMPv2c Configuration
Allows you to grant read or read-write access via SNMPv2c, and to specify the related
community string.
Setup softtool

R&S ZNB Series Specifications

General

Brand	R&S
Model	ZNB Series
Category	Measuring Instruments
Language	English