GUI reference
R&S
®
ZNB/ZNBT
752User Manual 1173.9163.02 ─ 62
● Presets tab............................................................................................................752
● Calibration tab.......................................................................................................753
● User Interface tab..................................................................................................755
● Messages tab........................................................................................................757
● Channel Bits tab....................................................................................................758
● Advanced tab........................................................................................................ 759
● Power tab..............................................................................................................761
● Recovery tab.........................................................................................................763
● HUMS tab..............................................................................................................763
Presets tab
Specifies the behavior of the R&S ZNB/ZNBT upon a preset.
Preset Scope
Defines whether a preset affects all open recall sets ("Instrument") or the active recall
set only.
The "Preset Scope" applies to the GUI and to the SYSTem:PRESet[:DUMMy] com-
mand. The *RST command always resets all open recall sets.
Remote command:
SYSTem:PRESet:SCOPe
Remote Preset Configuration
"Align *RST to User Defined Preset" defines the behavior of the *RST and
SYSTem:PRESet commands. If checked, and if a valid setup file is selected in the Pre-
set Configuration section, then they perform a user-defined preset. Otherwise, they
perform a factory preset.
Remote command:
SYSTem:PRESet:REMote[:STATe]
Global Settings
The two buttons reset all directory settings (e.g. the directories for storing trace data,
limit lines, calibration data...) and all settings in the "Printer Setup" dialog to default val-
ues. See Chapter 5.14.4, "Printer Setup dialog", on page 675.
Remote command:
n/a
Setup softtool
To Next Page
Loading...
Need help?
General
