R&S ZNB Series - 7.3.14.14 [SENSe:]ROSCillator...

Command reference
R&S
®
ZNB/ZNBT
1297User Manual 1173.9163.02 ─ 62
MANual
Enables the manual configuration of independent AGC settings
for each segment, drive port and receiver. See [SENSe<Ch>:
]POWer:GAINcontrol and [SENSe<Ch>:]SEGMent<Seg>:
POWer:GAINcontrol.
*RST: LDIS
Example: See [SENSe<Ch>:]POWer:GAINcontrol
Manual operation: See "AGC Mode" on page 580
[SENSe<Ch>:]POWer:LOSuppress[:STATe]
<Boolean>
Activates/deactivates "LO Suppression" for channel <Ch>.
"LO Suppression" lowers the LO power of all receivers and thus the power leaking out
of the test ports.
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> OFF (0)
LO suppression active
ON (1)
LO suppression inactive
*RST: OFF
Manual operation: See "LO Suppression" on page 579
7.3.14.14 [SENSe:]ROSCillator...
The [SENSe:]ROSCillator... commands control the frequency reference signal.
[SENSe:]ROSCillator:EXTernal:FREQuency................................................................... 1297
[SENSe<Ch>:]ROSCillator[:SOURce]............................................................................ 1298
[SENSe:]ROSCillator:EXTernal:FREQuency <ExtClockFreq>
Specifies or queries the frequency of the external reference oscillator.
Parameters:
<ExtClockFreq> Frequency of the external reference clock signal.
Range: See the data sheet of your analyzer.
*RST: 10 MHz
Default unit: Hz
SCPI command reference