R&S ZNB Series - 7.4 HUMS and service date commands; 7.4.1 SNMP;REST commands

Command reference
R&S
®
ZNB/ZNBT
1439User Manual 1173.9163.02 ─ 62
Suffix:
<Ch>
.
Channel number
Parameters:
<Type> BEFore | AFTer
BEFore
is appropriate if the device needs to be triggered before the data
is acquired (typical example: a power meter which is used for
power calibration)
AFTer
is appropriate if the device needs to be triggered just after data
acquisition (typical example: an external generator which must
be reconfigured to get ready for the next measurement)
*RST: AFTer
Example: See TRIGger:CHANnel<Ch>:AUXiliary[:ENABle]
on page 1437
7.4 HUMS and service date commands
This section provides the commands that are related to the Rohde & Schwarz Health
and usage monitoring service (HUMS), which is available on various Rohde & Schwarz
instruments.
For background information, see the R&S HUMS User Manual.
● SNMP/REST commands.....................................................................................1439
● System information commands...........................................................................1443
● Device tags commands.......................................................................................1453
● Utilization commands..........................................................................................1454
● Service date commands......................................................................................1461
7.4.1 SNMP/REST commands
These commands configure the SNMP and REST interfaces to R&S HUMS.
They all require software option R&S ZNB/ZNBT-980.
SYSTem:COMMunicate:SNMP:COMMunity:RO.............................................................. 1440
SYSTem:COMMunicate:SNMP:COMMunity:RW..............................................................1440
SYSTem:COMMunicate:SNMP:CONTact........................................................................1440
SYSTem:COMMunicate:SNMP:LOCation....................................................................... 1441
SYSTem:COMMunicate:SNMP:USM:USER....................................................................1441
SYSTem:COMMunicate:SNMP:USM:USER:ALL?........................................................... 1441
SYSTem:COMMunicate:SNMP:USM:USER:DELete........................................................ 1442
HUMS and service date commands